DIY Cold Frame

Just planted some lettuce and spinach and hope to extend its production as late as possible.  Hate to spend money, so found this old kitchen cupboard and a storm glass that is close in size and put them together.  We have lots of cupboards and windows, but i did have to buy the t-hinges.  Tons of hinges around our place, but no t-hinges.  It’s likely that future cold frames, i’ll use the hardware from the door of the cupboard, but the door on this one was missing already.

 

image
Cupboard found – missing door.
image
Old aluminum framed storm glass – nasty things, but perfect for this project.
image
Cleaned up and painted with paint we already have.  I used an outdoor rated spray paint simply because it needed using before it became useless and won’t spray out.  Dark colour is great for absorbing heat.  Before painting, i removed all extraneous hardware.

 

image
Cheap hinges from Orscheln’s
image
As you can see the top hole of this hinge doesn’t reach the side board, so using a Sharpie marker, i located a spot that would reach.
image
Then using our drill press made an extra hole in each.  However, when i installed the hinges, I found that two screws would be sufficient for the hinged glass ‘door’ would have been fine.
image
Box completed – no use doing anything to the inside though i may add some sort of insulation on the bottom.
image
Voila!  Ready to go to work.  Too early yet – we are expected to have temps in high 80s for another week!

image