Tag Archives: lumber

Repairing/Rebuilding Trashed Feed Bunks

Doing MUCH better with ragweed allergies to the point that, as long as i stay far away from the plants themselves, i can spend considerable time outside without effects and even without taking meds.  Almost back to health.

So, during this transition, i’ve taken the task of dragging all our bits and pieces of feedbunks together and making a plan to repair and rebuild to the extent of my ability and with no other expense except labour and reasonable amount of time.

image

image
This feedbunk frame will be attended to last – i think this chrysalis is still going, so i’ll wait until the monarch butterfly emerges.
image
Drill hole through liner and into the metal frame, then screw in these screws to hold tub in bunk properly.
image
After the tub is screwed into place, the bunk is turned over to reveal all the missing braces that will need replacing.
image
I dragged an old mangled gate out of the trash pile to cut to length for the bunk braces.  This DeWalt sawzall (reciprocating saw) does the job in no time.
image
After cutting a piece of the gate to 30 inches,  it is placed in the bench vise as shown.
image
Then with some muscles, I crank down the vise to squish each end flat.
image
After marking proper placement for the hole, i use the drill press to make it easier to drill a hole on each end.
image
Then mark the spot on the feedbunk and drill a hole through the brace with my handheld cordless DeWalt drill.
image
Line up my newly made brace with the existing brace on the bunk and run a bolt through. I’m not spending any money on this project, so using old bolts we already had.  However, i discovered the old bolts were fine thread, so i did have to purchase fine thread hex nuts at $.19/each from Orscheln’s.
image
Ripping old board salvaged from another project into four strips to be used as replacement runners on feedbunks.

 

image
Drilled then bolted runner to existing rotted metal runner.

 

image
Project almost complete.
image
Added chains on one end to make it easier to hook onto to move the bunk around.  Chains are leftovers from old and mangled gates.
image
Finished!

Repurposing Lumber

photos 001 - Copy
Assembling the tools and supplies usually takes longer than accomplishing the task!

Last summer, we took down the old horse barn behind our house and salvaged as much lumber as possible.  Built in 1899, it had far outlived its usefulness and had become, not only an eyesore, but unsafe as well.  Jeff McCotter used some of the planks and timbers to build a stunning platform bed, as well as, these beautiful picture frames.  I finally got around to taking some old glass to Hometown Hardware  and having glass cut for them, then i finally ordered and received the frame turn buttons to hold the photos in and the hangers, then finally cut foam board pieces for backing.  Then FINALLY, this morning, assembled the whole affair.  If you had frames made like i did, would you want them to come back with glass, backing, turn buttons and hanger already installed?  or would you prefer gathering the materials and doing those parts yourself?

turn buttons and hanger installed on one picture
Turn buttons and hanger installed on one picture. I discovered that the screwdriver set for my DeWalt 18V power drill did not contain a driver small enough for these tiny screws. I ended up using a hand screwdriver which was probably the better choice for this job anyway.
Finished and hanging.  Might look better stained darker, but for now, i'll enjoy them au naturale.
Finished and hanging. Might look better stained darker, but for now, i’ll enjoy them au naturale.
Bed 030
Hand crafted platform bed built entirely of planks and posts from our vintage 1899 horse barn from the Lamme Farm.

Bed 018