Tag Archives: screws

DIY Cold Frame

Just planted some lettuce and spinach and hope to extend its production as late as possible.  Hate to spend money, so found this old kitchen cupboard and a storm glass that is close in size and put them together.  We have lots of cupboards and windows, but i did have to buy the t-hinges.  Tons of hinges around our place, but no t-hinges.  It’s likely that future cold frames, i’ll use the hardware from the door of the cupboard, but the door on this one was missing already.

 

image
Cupboard found – missing door.
image
Old aluminum framed storm glass – nasty things, but perfect for this project.
image
Cleaned up and painted with paint we already have.  I used an outdoor rated spray paint simply because it needed using before it became useless and won’t spray out.  Dark colour is great for absorbing heat.  Before painting, i removed all extraneous hardware.

 

image
Cheap hinges from Orscheln’s
image
As you can see the top hole of this hinge doesn’t reach the side board, so using a Sharpie marker, i located a spot that would reach.
image
Then using our drill press made an extra hole in each.  However, when i installed the hinges, I found that two screws would be sufficient for the hinged glass ‘door’ would have been fine.
image
Box completed – no use doing anything to the inside though i may add some sort of insulation on the bottom.
image
Voila!  Ready to go to work.  Too early yet – we are expected to have temps in high 80s for another week!

image

Rehanging A Curtain Rod

Repairs on the farm, in the house, car, whatever are neverending.  When renovating our old house to be used as a guest house (into which we subsequently moved), it was challenging to deal with the old plaster walls when it comes to hanging things. Some months back, I had to ‘rehang’ this curtain rod.

Check out this helpful wikihelp site for determining the best equipment to use for your specific situation;  How to Put Anchor Screws In A Wall

Curtain Rod repair
Sometimes the plaster just crumbles immediately, sometimes, like this case, it took a couple of years, and the screws and plastic anchors pull out.

 

curtain rod repair
Fill holes with nail hole repair stuff and let dry.
curtain rod repair
Carefully sand it down with steel wool.
Curtain rod repair
Fill the holes with nail hole repair.
curtain rod repair
Drill new holes and insert new plastic screw anchors
curtain rod repair
Touch up paint on repaired wall and reattach rod bracket
Curtain rod repair
Voila! Good as before!
Curtains
I really like the curtain rod rings – especially for applications where you might be opening and shutting the curtains oftens. They just glide so nicely by hand without all the challenges of installing traverse rods.